Inverter FRN Fuji

Specification of Inverter FRN Fuji

Call for more information about this product

IGBT Module , Fuji Inverter , Inverter Fuji

• A braking circuit is built in the AC Drives of all the capacities.


• Built-in PG feedback circuit is standard equipment.


• An optional keypad is available.

• Overload capacity: 200% for 10s


• Current response: 5 times greater than previous models (compared with the)


• Reduction of torque ripple realizes low vibration.


• Reduced roll-back during starting up.

• Current response (ACR): 500Hz


• Speed control accuracy: ±0.01%

• 200% of rated current for 10s
  
  (Overload begins from 80% continuous operation with a carrier frequency of 10kHz.)

• A single AC Drive can control an induction motor (open/closed loop control) and a synchronous motor (the optional PG interface card is required).

• FRENIC-Lift AC Drives are available in a series with capacities ranging from 4.0 to 45kW for three-phase 400V model.
  
  5.5 to 22kW for three-phase 200V model.
  
  2.2kW for single-phase 200V model.

• Applicable to the inputs by open collector/complementary output as a standard specification (Encoder power supply is switchable between +12V and +15V.)


• Applicable to the inputs from the 5V line driver as an option


• Applicable to Sin/Cos, Serial interface (EnDat2.1) and Parallel interface (4-bit gray code, UVM 3-bit code)

• DC bus capacitor life: 7 years


• Electrolytic capacitor life on the printed circuit boards: 7 years


• Cooling fan life: 5 years


• Life warning signal


• Recording and display of cumulative operating time


• Recording and display of cumulative operations

• EC Directives (CE Marking) (EN61800-3)


• Safety standards (EN954-1)


• Sink/source switchable


• RS-485 communications (Modbus RTU) is adopted as standard equipment.


• CAN Bus is adopted as (optional)


• DCP3 communication (-EA version)


• EN12015 and EN12016 compliance by adding external EMC filter and DCR.

• AC Drive support loader software is provided.


• A multi-function keypad (with backlit LCD) makes it possible to copy or edit the function code data.